wall heat flux
can wall heat flux values be obtained from phoenics software. If yes then how?
|
Hi niharika,
If the heat flux is at a PLATE boundary with a surface temperature, then the heat flux will be printed in the RESULT file in the 'Sources and sinks' section as the Nett source of TEM1 for that object. For a BLOCKAGE object, the nett TEM1 source will be for the entire object, not individual faces. You can also STORE(QDX,QDY,QDZ) (either directly in Q1 or from Menu, Models, Solution control / Extra variables, STORE). At the end of the run, these will be filled with the X-, Y- and Z-directed heat fluxes. With a little InForm you can add these up over any area. That is the best answer I can give you unfortunately without knowing more about your case. If that doesn't help, could you perhaps be more specific and we will try our best to help. Thanks |
Thank you so much for the reply. I have a blockage which is a heat source in between the domain fluid. so it has two boundaries with the domain fluid. I want to know the wall heat flux for the two boundaries. Can it be done? I will try to store the variables you suggested and thank you very much.
|
Hi again,
Storing those variables should give you the information you need. If that doesn't work please let me know and I will try to help. Thanks, |
All times are GMT -4. The time now is 17:43. |