icem and star-cd
I am using Star-cd3.10B,i think that the post ptocess in it is not good for me ,i want to output the star-cd's result to Icem cfd,then process it with Icemis, is it possible? how to output the result as Icem format?
|
Re: icem and star-cd
Icem output was not available in 3.1b. You have to upgrade to the latest version.
|
Re: icem and star-cd
thank you very much!!linux 3.15 ok?
|
Re: icem and star-cd
thank you very much!!but I enter "icem"in the output ,the the following is PRO *> icem
ENTER ROOT OR WRITE what is the meaning? |
Re: icem and star-cd
It is a "placeholder" for the eventual ICEM conversion command. It has no real code behind it until later versions of prostar.
|
Re: icem and star-cd
Only ProSTAR v3.103.520 can output to ICEM's Visual3. I guess it's finally out but is available only through special request. Contact your agent/distributor. At this time of writing, the newest version of STAR-CD, v3.150A, comes only with ProSTAR/AM v3.103.519.
Alternative technique: just export in Tecplot format and have Visual3 open it. |
All times are GMT -4. The time now is 06:05. |