|
Trimming and Mapping Methods with ES-ICE
Dear People
I’m trying to do a simulation of an ASTM CFR engine using the “Method Mapping (es-ice)” and I am with a lot of difficulty to finish it. When finishing the mapping stage I accomplished the verification of negative volumes in the mesh and the result is zero negative volumes, but when I do the verification for the “Create Result – (es-ice)” appear several negative volumes. Can anybody help me about the method mapping? Another doubt, when I do for the trimming method mistake happens at the moment of cutting the port, because that? I have the geometry of the engine, if you could help me I can send by e-mail. Regards Flavio Zancanaro |
| All times are GMT -4. The time now is 09:07. |