drawing streamtraces(surface line) in slices
Hi friends
I'm drawing streamtraces in slices for hydraulic channel , but I can not use surface line and nothing is shown!!!!! It only shows the volume line(drawing lines are very irregular:(:() What can I do to show the surface line:confused::confused:? best regards pouya ahmadi |
At this time you cannot place surface streamtraces on a slice. The same effect can be achieved by extracting the slice then seeding surface streamtraces on the extracted zone.
|
solved!!!
thank you:o:o:o |
All times are GMT -4. The time now is 14:01. |