|
[Sponsors] |
May 28, 2018, 19:15 |
drawing streamtraces(surface line) in slices
|
#1 |
New Member
pouya
Join Date: Jun 2017
Posts: 11
Rep Power: 8 |
Hi friends
I'm drawing streamtraces in slices for hydraulic channel , but I can not use surface line and nothing is shown!!!!! It only shows the volume line(drawing lines are very irregular) What can I do to show the surface line? best regards pouya ahmadi |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] refineWallLayer Error | Yuby | OpenFOAM Meshing & Mesh Conversion | 2 | November 11, 2021 11:04 |
problem during mpi in server: expected Scalar, found on line 0 the word 'nan' | muth | OpenFOAM Running, Solving & CFD | 3 | August 27, 2018 04:18 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |