|
[Sponsors] |
November 8, 2012, 15:05 |
Blade Edge Mesh Improvement
|
#1 |
Member
|
I have successfully reduced the yplus values all over to near 1. But just at the blade edges, in a very narrow band, I have yplus values over 500. I don't see a way to target and refine these. I'm sure there must be. Does anyone know how to accomplish this?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
[ANSYS Meshing] avoid to mesh the inside of the blade | swiss_zhang | ANSYS Meshing & Geometry | 1 | June 9, 2011 07:37 |