|
[Sponsors] |
[ICEM] Exporting blocking/mesh for a similar geometry |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 8, 2013, 03:28 |
help
|
#6 |
New Member
samiullah
Join Date: Aug 2012
Posts: 21
Rep Power: 13 |
'm new to ansys fluent and doing cfd of shell and tube heat exchanger . in which there 7 tubes . i made 2d geometry of heat exchanger with 2 baffles .. pic this geomtry attached .. plz tell me it is ri8 or wrong ...plz
Last edited by samidabest; January 8, 2013 at 03:29. Reason: pic |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
exporting geometry in ICEMCFD which is created in AUTOCAD | arif.iut.09 | ANSYS Meshing & Geometry | 1 | June 1, 2010 09:52 |
[ICEM] Geometry too large! | brunorgs | ANSYS Meshing & Geometry | 10 | May 20, 2010 21:20 |
[Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 04:53 |
Exporting geometry from Solidworks to ICEM! | Usman | Main CFD Forum | 2 | November 27, 2007 12:01 |
Virtual/Real geometry. | Jack Keays | FLUENT | 9 | June 15, 2000 23:39 |