|
[Sponsors] |
December 29, 2012, 12:15 |
Icem
|
#1 |
New Member
David Lopez
Join Date: Dec 2012
Location: Venezuela
Posts: 9
Rep Power: 13 |
Good afternoon, the meshing in ANSYS ICEM-CFD. in detail mesh, Set Use Automatic Tet Inflation from None to Program Controlled. and I throw these warnings
* Pre-generation layer is stopped inflation Because of side face limitation, proximity collisions and quality. * Pre-inflation failed with non prism mesh generated, please check the attachments on the faces inflation. if anyone can help me with this. thanks if someone could get close to a solution, I'd be grateful. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
PEM Fuel cell module meshes. ICEM vs workbench | aarvay | FLUENT | 24 | March 2, 2020 06:50 |
[ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
[ICEM] Meshing adjacent wall geometry and simple ICEM questions | everdimension | ANSYS Meshing & Geometry | 25 | June 20, 2012 04:25 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |
ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 06:46 |