 |
 |
 |
|
|
|
[Sponsors] | ||||
January 14, 2013, 10:43
|
Blocking with 2 fluids
|
#1 |
|
New Member
tetsuya
Join Date: Nov 2011
Posts: 6
Rep Power: 14  |
Hi.
I'm now trying to make a mesh with 2 fluid (fluid and aluid 2) With a fluid(fluid), I could make a mesh correctly, but chose some blocks as fluid2, then mesh has a problem like a picture. Can anyone tell me how to resolve it? Regards. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Blocking and Meshing around a vane vortex generator | Crank-Shaft | ANSYS Meshing & Geometry | 5 | January 17, 2016 23:29 |
| [ICEM] Blocking and Symmetry | BrolY | ANSYS Meshing & Geometry | 32 | August 24, 2012 03:13 |
| [ICEM] Using Blocking with ICEM (infinite blocking lines appeared) | Touré | ANSYS Meshing & Geometry | 2 | August 5, 2012 17:27 |
| [ICEM] Blocking strategy | BrolY | ANSYS Meshing & Geometry | 0 | July 22, 2010 04:46 |
| Differents fluids separated by wall | phil | FLUENT | 0 | January 18, 2007 02:43 |
Threaded Mode
