|
[Sponsors] |
February 5, 2013, 18:50 |
|
#3 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 29 |
thank your far for you answer. i will make the split where the slope begins tomorrow.
I will try to open up the lower mesh, but that will take too much time... quality can also get worse... i will see what i can do |
|
February 6, 2013, 02:56 |
|
#4 |
Senior Member
AB
Join Date: Sep 2009
Location: France
Posts: 323
Rep Power: 21 |
Can't you add 1/4 of O-grid instead of having this distorsion ?
|
|
February 7, 2013, 11:00 |
|
#5 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 29 |
thanks FAR and broly. the split was a good step. then i came across the project curve on surface to get the same curve in the rear back, i checked the ratio of how the rear back was bigger than the front, then i used it in the scale geometry option, it gave me the same topology but bigger to keep a good quality here is a screenshot:
Last edited by diamondx; February 7, 2013 at 12:07. |
|
|
|