|
[Sponsors] |
February 20, 2013, 10:59 |
Negative Determinant
|
#1 |
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 17 |
I've exported a mesh generated in Ansys meshing to the ICEM Input File(.prj) format.
Then I imported it into ICEMCFD. When I checked the determinant of the imported mesh in ICEMCFD, I found it to be a negative value. Usually within workbench, I check the orthogonal quality, skewness and Minimum corner angle for the mesh and I found them good - Orthogonal quality - 0.15 Skewness - 0.93 Minimum corner angle - 60 to 162 [deg.] But the problem is with the negative determinant which I checked in ICEM after importing the mesh there. Could some one please clarify this Also is there a way to check the "equivolume skewness" in ICEMCFD I mean I'm not sure if the metric "equiangle skewness" of ICEM is in comparison with the skewness measure of Fluent.
__________________
Best regards, Santhosh. Last edited by saisanthoshm88; February 20, 2013 at 12:50. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |