|March 21, 2013, 07:47||
1D Pipe Meshing in Hypermesh
Join Date: Jan 2013
Posts: 1Rep Power: 0
I'm trying to mesh pipe in 1D in Hypermesh but I have some difficulties due to my lack of knowledge.
I don't know how to fill the Section properties...
What I know about my pipe is this:
Outside Diameter (DO): 60.3
Wall Thickness (I think it is TW): 3.2
Can anyone help me?
Material: Steel (210 000,0.3)
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Simple pipe meshing - problems with y+ in CFX||Keizers||ANSYS Meshing & Geometry||23||January 15, 2015 09:00|
|How pervasive is the use of hypermesh for CFD meshing ?||saisanthoshm88||Mesh Generation & Pre-Processing||0||March 3, 2013 14:35|
|[GAMBIT] GAMBIT Meshing of Pipe with Holes Perpendiculer to Flow Stream||rocketman1151||ANSYS Meshing & Geometry||7||November 30, 2011 03:39|
|[GAMBIT] Meshing a pipe||vedravi||ANSYS Meshing & Geometry||1||March 25, 2010 14:19|
|Terrible Mistake In Fluid Dynamics History||Abhi||Main CFD Forum||12||July 8, 2002 09:11|