|May 15, 2013, 16:36||
overlapping heat exchanger cores- as in ansys user guide
Join Date: Apr 2013
Posts: 40Rep Power: 4
Hai, thanks for your time...
im simulating heat exchanger using ansysfluent 14.0 and i wanted to use dual cell model. the hot and cold fluid zones are not overlapping and i dont know how to make them.
According to the ansys user manual..
If the mesh file does not already contain overlapping heat exchanger cores for primary and auxiliary fluids, then you must create a duplicate of the zone that represents the core using the following text command:
mesh → modify-zones → copy-move-cell-zone
You will then be prompted to enter the ID of the zone you want to copy, and either the distance for translation in each of the axes or the rotational angle, origin, and axis.
& when i try
>mesh → modify-zones → copy-move-cell-zone
modify-zones/: Enter the modify zones menu.
?: Enable help mode. Type "q" to return to command mode
invalid command [copy-move-cell-zone]
invalid command 
i dont know where`s my mistake. i really don`t have any idea,how to respond the command. can anyone please help me with this...??
|Thread||Thread Starter||Forum||Replies||Last Post|
|Double pipe heat exchanger||mohcin||FLUENT||11||November 25, 2014 02:21|
|heat transfer in heat exchanger||chinna||FLUENT||0||April 4, 2013 13:25|
|how to modeling heat by fluent and ansys?||njiit||FLUENT||0||December 9, 2009 01:39|
|Tube in Tube heat exchanger( But I got error)||Young||CFX||2||September 26, 2008 01:35|
|Heat Exchanger...TWO||Walid||CFX||2||July 11, 2005 19:04|