|
[Sponsors] |
May 26, 2013, 23:16 |
how to add a node?
|
#1 |
Member
jiaqi wang
Join Date: Jan 2013
Posts: 36
Rep Power: 13 |
Hi there,
I hope to use Vertex sizing control in my mesh to refine certain region. But I don't know how to add a node into the model. Can anyone told me how to do that? My model is created in Creo and used to play a CFX simulation. Capture.JPG Thanks, itsqi7 |
|
May 27, 2013, 02:08 |
|
#2 |
Senior Member
|
If it's refinement you are looking for, then you can use "sphere of influence" for body sizing:
All you need is to define a coordinate system at your point. |
|
May 27, 2013, 03:51 |
|
#3 |
Member
jiaqi wang
Join Date: Jan 2013
Posts: 36
Rep Power: 13 |
Thanks a lot. I found it in the Mesh. I tried to add plane in designmodeler but it didn't work. So now it works.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mpirun, best parameters | pablodecastillo | Hardware | 18 | November 10, 2016 12:36 |
[ICEM] Expanding and constant node distribution | siw | ANSYS Meshing & Geometry | 2 | February 4, 2013 13:47 |
999999 (../../src/mpsystem.c@1123):mpt_read: failed:errno = 11 | UDS_rambler | FLUENT | 2 | November 22, 2011 09:46 |
License server not visible from master node | Charles | FLUENT | 0 | October 30, 2007 17:48 |
Full Fluent license required for the master node? | Paul | FLUENT | 1 | September 1, 2006 04:26 |