|June 3, 2013, 11:46||
Modeling help for new member
Join Date: May 2013
Posts: 8Rep Power: 3
I have run a few 2d, steady state, single phase heat transfer models. No problem.
Basically, natural convection of water over a heated isothermal flat plate (I'm building up to more complex simulations). I want to repeat the simulation with a modified surface (my research). I wanted to apply an isothermal condition at the bottom of the structures and see how the temperature varies through it. So now I would apply an isothermal condition at the base of the structures.
The problem is I don't know how to have the two different materials (solid and fluid) in the model.
|June 4, 2013, 07:48||
Ghazlani M. Ali
Join Date: May 2011
Blog Entries: 23Rep Power: 19
New to ICEM CFD, try this document --> http://goo.gl/G2gkE
|Thread||Thread Starter||Forum||Replies||Last Post|
|Native ParaView Reader Bugs||tj22||OpenFOAM Paraview & paraFoam||265||September 16, 2014 10:19|
|Version 15 on Mac OS X||gschaider||OpenFOAM Installation||120||December 2, 2009 11:23|
|Compilation errors in ThirdPartymallochoard||feng_w||OpenFOAM Installation||1||January 25, 2009 07:59|
|OpenFoam 14 installation problem||gfcoppola||OpenFOAM Installation||20||November 2, 2007 14:38|
|DecomposePar links against liblamso0 with OpenMPI||jens_klostermann||OpenFOAM Bugs||11||June 28, 2007 17:51|