[GAMBIT] Two edges instead of one

abc197 · July 17, 2013, 14:40

This may be one of the simplest of gambit, but I am stuck. While subtracting smaller face from bigger one(retaining smaller one), at the interface of both, I am getting two edges generated for the same interface edge. Same is happening in case of volumes(two faces are generated). Can anybody explain this? Problem is, which one am I supposed to select while assigning boundary conditions or zones.

reza_farzin · July 18, 2013, 13:34

Quote:

Originally Posted by abc197

This may be one of the simplest of gambit, but I am stuck. While subtracting smaller face from bigger one(retaining smaller one), at the interface of both, I am getting two edges generated for the same interface edge. Same is happening in case of volumes(two faces are generated). Can anybody explain this? Problem is, which one am I supposed to select while assigning boundary conditions or zones.

after subtract, you can connet two edges(interface) by edge/connect

-mAx- · July 23, 2013, 00:57

pictures always help

abc197 · July 23, 2013, 06:58

Thanks for your replies, I have managed to disconnect the edges.

July 17, 2013, 14:40	Two edges instead of one	#1
abc197 Member Ravi Agrawal Join Date: Dec 2012 Posts: 38 Rep Power: 13	This may be one of the simplest of gambit, but I am stuck. While subtracting smaller face from bigger one(retaining smaller one), at the interface of both, I am getting two edges generated for the same interface edge. Same is happening in case of volumes(two faces are generated). Can anybody explain this? Problem is, which one am I supposed to select while assigning boundary conditions or zones.

July 23, 2013, 00:57		#3
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	pictures always help __________________ In memory of my friend Hervé: CFD engineer & freerider

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] SnappyHexMesh for internal Flow	vishwa	OpenFOAM Meshing & Mesh Conversion	24	June 27, 2016 08:54
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
[snappyHexMesh] snappyHexMesh aborting	Tobi	OpenFOAM Meshing & Mesh Conversion	0	November 10, 2010 03:23
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 19:43

July 23, 2013, 06:58		#4
abc197 Member Ravi Agrawal Join Date: Dec 2012 Posts: 38 Rep Power: 13	Thanks for your replies, I have managed to disconnect the edges.