|
[Sponsors] |
[ICEM] Converting or projecting Edge (of blocking) to generate curve |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 9, 2013, 23:55 |
Converting or projecting Edge (of blocking) to generate curve
|
#1 |
Senior Member
Ashwani
Join Date: Sep 2013
Location: Hyderabad
Posts: 154
Rep Power: 12 |
Hi,
My problem is that our solver reads CGNS file. Now, I have a mesh with multiple blocks. A face is shared by 3blocks. But the face is one surface and named like inlet. Now, I want this face should be divided in 3 surfaces to match the respective blocks. (This will help our solver to recognize each sub-face as part of respective blocks, which are understood to be zones under CGNS nomenclature. ) The mesh file is of NACA 0015. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ANSYS Meshing] blocking 2D planar, problem associate edge to curve | hadrien51 | ANSYS Meshing & Geometry | 10 | February 21, 2012 12:37 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |