CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > ANSYS Meshing & Geometry

[ANSYS Meshing] Interface creation

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   October 7, 2014, 02:17
Default Interface creation
  #1
Member
 
shikha
Join Date: Aug 2013
Posts: 36
Rep Power: 3
SHIKHA BHUYAN is on a distinguished road
Hello friends,

I have created a rotating zone (inside which a rotor exists, and have done boolean operation) inside a stationary domain.Now, I want to create an interface since I am having two domains (though both are fluid domain).
I have done the named selection in ansys mesh itself. I wanted to have rotor part (cylinderical zone) and stator part (cubical part) named separately and create the interface between them. But principle 2d region for the stator part does not show the faces of rotating part so that I could create the interface. I have attached the snapshot of the model for your reference.
I am not getting where I am going wrong. Kindly if any one can help me!
Attached Images
File Type: jpg Fluid Flow CFX.jpg (18.0 KB, 6 views)
SHIKHA BHUYAN is offline   Reply With Quote

Old   October 12, 2014, 11:28
Default
  #2
Senior Member
 
amin.z's Avatar
 
Amin
Join Date: Oct 2013
Location: Somewhere on Earth
Posts: 297
Rep Power: 5
amin.z is on a distinguished road
Quote:
Originally Posted by SHIKHA BHUYAN View Post
Hello friends,

I have created a rotating zone (inside which a rotor exists, and have done boolean operation) inside a stationary domain.Now, I want to create an interface since I am having two domains (though both are fluid domain).
I have done the named selection in ansys mesh itself. I wanted to have rotor part (cylinderical zone) and stator part (cubical part) named separately and create the interface between them. But principle 2d region for the stator part does not show the faces of rotating part so that I could create the interface. I have attached the snapshot of the model for your reference.
I am not getting where I am going wrong. Kindly if any one can help me!
Hey
In shared faces, do you have 1 face? Or 2 faces?
You should have 2 faces and then use connection for create interface!
__________________
Best regards,
Amin
amin.z is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Wind turbine simulation Saturn CFX 34 October 16, 2014 05:27
sliding mesh problem in CFX Saima CFX 35 May 12, 2014 20:28
Question about heat transfer coefficient setting for CFX Anna Tian CFX 1 June 16, 2013 06:28
Error finding variable "THERMX" sunilpatil CFX 8 April 26, 2013 07:00
RPM in Wind Turbine Pankaj CFX 9 November 23, 2009 05:05


All times are GMT -4. The time now is 00:10.