|
[Sponsors] |
December 1, 2014, 04:25 |
Connecting surfaces
|
#1 |
New Member
Juan Ignacio
Join Date: Nov 2014
Posts: 2
Rep Power: 0 |
Hello
I am trying to draw a two concentric parallel tubes with 2D dimensions using ANSYS. I need to draw two surfaces which represents two fluids. So, I would like to kinow how can I connect both surfaces using just one one line on the intersection. When I draw the rectangle at the bottom I am able to create the surface but the surface of the upper rectangle is not created I enclose and image Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to get forces on Iso-Clip Surfaces and How to get forces in cylindrical coordinat | CFD XUE | FLUENT | 3 | March 18, 2015 03:28 |
[ANSYS Meshing] Surfaces with high curvature | mohammad | ANSYS Meshing & Geometry | 9 | November 24, 2014 01:02 |
[Commercial meshers] How to get rid of internal walls (surfaces)? | bmikuz | OpenFOAM Meshing & Mesh Conversion | 17 | December 5, 2013 15:24 |
Modeling both radiation and convection on surfaces - Ansys Transient Thermal R13 | s.mishra | ANSYS | 0 | March 31, 2012 04:12 |
[Commercial meshers] Hypermesh, connecting surfaces | Schuschi | OpenFOAM Meshing & Mesh Conversion | 1 | November 7, 2010 03:27 |