|
[Sponsors] |
March 17, 2015, 05:46 |
pipe
|
#1 |
New Member
afsaneh
Join Date: Feb 2015
Posts: 12
Rep Power: 11 |
hello
i work on simulating pressure in a pipe line that gas flow in it , i generate my geometry in gambit and meshing it but when i run it in ansys the is a problem, my velocity profile is zero and uniform can any body help me that what is my problem? i defined 3 boundary : pressure inlet, pressure outlet and wall, my inlet pressure is 12 bar and the gas go into atmosphere i think my geometry defining has a problem. https://www.dropbox.com/s/aicfjwg11c...d7392.dbs?dl=0 https://www.dropbox.com/s/a6kpzqnp6n...pe3d8.msh?dl=0 |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] DesignModeler Pipe within pipe | shields | ANSYS Meshing & Geometry | 13 | November 25, 2018 22:14 |
Double Walled Pipe Boundary | dahvqaz | FLUENT | 2 | December 5, 2012 10:14 |
My Revised "Time Vs Energy" Article For Review | Abhi | Main CFD Forum | 2 | July 9, 2002 09:08 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |