|
[Sponsors] |
March 18, 2015, 03:39 |
2D Prism Layer Issue
|
#1 |
New Member
Matthew de Haast
Join Date: Aug 2014
Location: Cape Town
Posts: 9
Rep Power: 11 |
Good day
I am trying to mesh an airfoil by first creating an unstructured mesh through blocking and then adding an inflation layer for the boundary layer. Overall it is not too bad but it creates a weird affect that can be seen in the picture below. Please could someone give me advice on how to negate the happening. Further some of the line elements in the boundary layer seem to be slightly skewed. Regards Matt |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
No prism layer mesh is generated, I don't know why... | capikrad | STAR-CCM+ | 6 | April 25, 2014 05:06 |
[ICEM] Prism Layer Starts Shrinking at Certain Point on 3D Blade Mesh | ndev | ANSYS Meshing & Geometry | 5 | March 28, 2014 17:28 |
[ICEM] Holes in the prism layer | Airon | ANSYS Meshing & Geometry | 3 | September 12, 2013 06:08 |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
[snappyHexMesh] snappy hangs while layer generation | bastil | OpenFOAM Meshing & Mesh Conversion | 3 | October 29, 2010 07:19 |