|
[Sponsors] |
[ANSYS Meshing] unable to create periodic zones in a dimpled tube. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 20, 2015, 05:12 |
unable to create periodic zones in a dimpled tube.
|
#1 |
New Member
Ashit Pawar
Join Date: May 2015
Posts: 1
Rep Power: 0 |
Hi all. i have a problem for with i need to model heat transfer with translational periodicity. i created a mesh and imported it in fluent and tried to make the zones periodic using the tui. i couldnt do is as the no. of elements on both the faces was different. so i mapped the mesh and tried it again but with no success. this time the error contained no information at all, it just said failed to create periodic zones. I need help. i have attached the images of geometry as well as the mesh and error.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM 1.6.x - CentOS 5.3 x86_64 | linnemann | OpenFOAM Installation | 68 | April 22, 2013 11:03 |
periodic boundary contion in tube banks | Zhihua | FLUENT | 1 | April 2, 2013 22:02 |
Create Zones in Fluent | jrg | FLUENT | 2 | September 20, 2007 14:11 |
How to create different zones in a 3-D volume. | Tonmoy Roy | FLUENT | 5 | February 28, 2004 11:47 |
multiblock to create cylinder tube ? | olivia | FLUENT | 1 | February 2, 2001 00:25 |