|
[Sponsors] |
[ANSYS Meshing] Non-conformal mesh regions are not communicating between each other |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 8, 2015, 06:08 |
|
#1 |
New Member
VINAY PRASAD
Join Date: Aug 2015
Posts: 8
Rep Power: 10 |
I have one body which I have divided ino 5 parts using slicing operation. And I have not formed multi body part since I want non conformal mesh. I have created mesh interface and also contact sizing in the contact between two non conformally meshed part of fluid domain yet it seams by seeing result, every part is working independently and there is no connection between parts. How to solve this issue???
Last edited by wyldckat; September 8, 2015 at 15:48. Reason: merged posts that were a couple of hours apart |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
[snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[ICEM] Problem making structured mesh on a surface | froztbear | ANSYS Meshing & Geometry | 4 | November 10, 2011 08:52 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |