|October 1, 2015, 05:09||
Join Date: Mar 2015
Posts: 1Rep Power: 0
Hi folks, this is my first thread, but the forum has helped me a lot! I'm at my first steps with Ansys.
I have a diferential volume that I want to mesh. I want to mesh the superior face and then "extrude" this mesh all the height of the volume in a regular way, 10 layers.
This is similar to I want to get
I tried with an edge sizing, it looks good on the exterior, but when I apply the inflation for the wall function, it ends all messy and untidy, also the mesh is not regular on the inside.
This is what I get when I apply inflation
I also tried using mapped face meshing, it looks, more regular, but again only in the edges.
This with maped face meshing
How can I solve this?
Thanks, and sorry for the bad English.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ANSYS Meshing] Can I use ANSYS Meshing for manual meshing?||Kirjain||ANSYS Meshing & Geometry||6||November 30, 2015 09:11|
|[gmsh] Vertex numbering is dense||KateEisenhower||Open Source Meshers: Gmsh, Netgen, CGNS, ...||7||August 3, 2015 10:49|
|[ANSYS Meshing] Icem meshing queries||Mfaizan||ANSYS Meshing & Geometry||21||July 30, 2015 23:10|
|ParaView Compilation||jakaranda||OpenFOAM Installation||3||October 27, 2008 12:46|
|Volume Meshing & Face Meshing? singularity of grid||ken||FLUENT||0||September 4, 2003 11:08|