|
[Sponsors] |
October 1, 2015, 05:09 |
Regular meshing
|
#1 |
New Member
Join Date: Mar 2015
Posts: 1
Rep Power: 0 |
Hi folks, this is my first thread, but the forum has helped me a lot! I'm at my first steps with Ansys.
I have a diferential volume that I want to mesh. I want to mesh the superior face and then "extrude" this mesh all the height of the volume in a regular way, 10 layers. This is similar to I want to get I tried with an edge sizing, it looks good on the exterior, but when I apply the inflation for the wall function, it ends all messy and untidy, also the mesh is not regular on the inside. This is what I get when I apply inflation I also tried using mapped face meshing, it looks, more regular, but again only in the edges. This with maped face meshing How can I solve this? Thanks, and sorry for the bad English. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
[ANSYS Meshing] Icem meshing queries | Mfaizan | ANSYS Meshing & Geometry | 21 | July 30, 2015 23:10 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |