|
[Sponsors] |
[ANSYS Meshing] URGENT: Mesh keeps failing at certain values within acceptable size range |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 30, 2017, 14:51 |
URGENT: Mesh keeps failing at certain values within acceptable size range
|
#1 |
New Member
Join Date: Sep 2017
Posts: 1
Rep Power: 0 |
Hi
Ive been trying to refine the mesh of element of a plate and tube heat exchanger consisting of two vertical tubes passing through two parallel rectangular horizontal fins with water in the tubes and air between the fins.# ive done all appropriate named selections and i am using automatic inflation program controlled fin thickness is 0.15mm max face size failure occurs at is 0.85 max size 4.333 i get an error message Mesher failed to finish inflation. Patch conforming mesh failed because of pyramid mesh intersecting opposite boundary or bad boundary or inflation mesh. how can i solve this im presenting in two days please help |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |