 |
 |
 |
|
|
|
[Sponsors] | ||||
February 5, 2016, 00:25
|
Meshing a portion in a 2-d face
|
#1 |
|
New Member
Hamza Arshad
Join Date: Feb 2016
Posts: 1
Rep Power: 0  |
Hello everyone,
I am currently working on 2-D simulation of a water tunnel which can be seen in the pic. The whole geometry is modeled as a single unit. Can anyone guide me that what to do if I want to mesh a particular portion of the face with a particular element size? The problem is that when I select the face, the whole geometry is selected as it is designed as a single unit. I want to select a particular region e.g a particular corner for a particular element size. Thanking in anticipation. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
| [ANSYS Meshing] inflation on the face other than source face of sweep meshing? | jayash | ANSYS Meshing & Geometry | 0 | April 16, 2014 04:11 |
| [ICEM] how to define periodic for free type face in hexa meshing | mingersai | ANSYS Meshing & Geometry | 0 | February 5, 2012 01:55 |
| Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |
Linear Mode
