|
[Sponsors] |
[ANSYS Meshing] Interlocking two body named selection |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 19, 2016, 01:02 |
Interlocking two body named selection
|
#1 |
Senior Member
Onur Özcan
Join Date: Feb 2016
Location: Istanbul/Turkey
Posts: 461
Rep Power: 12 |
Hi all,
I am taken a error : The mesh file exporter does not support overlapping geometry in named selection You think a sperical body and the other body is 20 microns thikness out of external radius of sperical body. All faces seperately chosen named selection but error above I have defined is available. Is it relevant to 20 microns thickness body? Is it not necessary to define named selection? Kind Regards, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
y+ and u+ values with low-Re RANS turbulence models: utility + testcase | florian_krause | OpenFOAM | 114 | August 23, 2023 05:37 |
Near wall treatment in k-omega SST | Arnoldinho | OpenFOAM Running, Solving & CFD | 38 | March 8, 2017 13:48 |
[OpenFOAM] Native ParaView Reader Bugs | tj22 | ParaView | 270 | January 4, 2016 11:39 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |