Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[TGrid] compresor cavities modeling using TurboGrid

Updated Threads

Reply

Search this Thread

September 16, 2016, 02:51	compresor cavities modeling using TurboGrid	#1
Red Ember Member Alex Join Date: Feb 2016 Posts: 81 Rep Power: 10	Hi to all How can I simulate compressor bleeding and cavities using TurboGrid only? Is it possible just to add cavern to shroud/hub curve? Whether it is necessery to combine TurboGrid and ANSYS Meshing or not? Thanks in advance

November 14, 2016, 01:37		#2
Red Ember Member Alex Join Date: Feb 2016 Posts: 81 Rep Power: 10	Still no ideas?

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] TurboGrid - problem with trailing edges ending with hub/shroud curve	TTM	ANSYS Meshing & Geometry	8	February 16, 2020 07:11
Files input for Turbogrid	Jun_Milan	CFX	0	July 10, 2014 23:34
May Focus Area: Turbulence Modeling	Jonas Larsson	CFD-Wiki	0	May 2, 2006 11:48
Modeling Flow/Saturation/Absorption in Fibers	Gene Dougherty	Main CFD Forum	0	June 6, 2003 14:49
CFD Modeling of Two-phase Flow in Small Dia.Tubes	Eric Poindexter	Main CFD Forum	2	September 22, 2000 09:21

All times are GMT -4. The time now is 19:30.