 |
 |
 |
|
|
|
[Sponsors] | ||||
May 3, 2009, 04:02
|
Creating a bell mouth inlet in DesignModeler
|
#1 |
|
New Member
Jenny
Join Date: May 2009
Posts: 8
Rep Power: 6  |
I am not a whiz using ANSYS DesignModeler, so just wondered whether anyone has developed a simple way of creating a bell mouth inlet on a duct in front of a fan and could explain how they've done it?
Thanks in advance for any advice. Jenny |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fluent3DMeshToFoam | simvun | OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ... | 48 | May 14, 2012 05:20 |
| Pulsating flow with non-reflective inlet boundary | cc1000 | CFX | 6 | April 27, 2009 08:10 |
| Inlet table in STAR-CD | Sachin | CD-adapco | 1 | March 26, 2008 11:22 |
| transitional inlet boundary condition | kamp | CFX | 1 | June 21, 2006 11:08 |
| what the result is negatif pressure at inlet | chong chee nan | FLUENT | 0 | December 29, 2001 05:13 |
Linear Mode
