|
[Sponsors] |
[ANSYS Meshing] Exporting Formatted Point Data |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 19, 2016, 10:37 |
Exporting Formatted Point Data
|
#1 |
New Member
Ewan
Join Date: Nov 2016
Posts: 15
Rep Power: 9 |
Hi there!
I have created a 'base case' geometry but now want to alter only a part of it. Rather than just exporting all of the coordinated and having to form surfaces etc again (there are a lot of them!) I was wondering whether I could actually output formatted point data for the surfaces, curves, and point? Many thanks for your time! Ewan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] 2 datas on one plot | Akuji | ParaView | 46 | December 1, 2013 14:06 |
water velocities (point data) are all zero | sophie_l | OpenFOAM Post-Processing | 2 | April 20, 2013 06:08 |
[ICEM] Question about Formatted Point Data | EphemeralMemory | ANSYS Meshing & Geometry | 0 | February 20, 2012 12:53 |
how to create the formatted point data for icemcfd | charles | CFX | 3 | February 28, 2006 20:01 |
exporting data | sourav | FLUENT | 2 | August 16, 2005 15:05 |