|
[Sponsors] |
[Other] DesignModeler: How to split a surface? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 22, 2010, 17:17 |
DesignModeler: How to split a surface?
|
#1 |
Senior Member
Xiaofeng Liu
Join Date: Mar 2009
Location: State College, PA, USA
Posts: 118
Rep Power: 17 |
I have a simple cylinder type of body. This body comes from a Revolve operation of a curve. I expect the side of the cylinder to be composed of two surfaces (which I will apply different boundary conditions). However, DM automatically merged the side of the cylinder into one surface when revolve.
The side of the sketch has two lines. In Gambit, the cylinder will have two surfaces. How do I let DM to do preserve the splitting surfaces? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
Free - Surface Flow: Split Fluid Forces acting on a Boat Hull | eee | CFX | 2 | August 28, 2009 08:36 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |