|November 19, 2010, 10:53||
Boundary Layer problems
Join Date: Nov 2010
Posts: 3Rep Power: 5
I'm facing some problems using Gambit to create a boundary layer in a 3D geometry.
As you can see in the image below, the BL doesn´t go all the way to the end of the face and it's causing problems in the volume mesh:
How can i solve this?
Thanks in advance!
|Thread||Thread Starter||Forum||Replies||Last Post|
|Turbulent Boundary Layer on a Flat Plate||Hoshang Garda||FLUENT||1||November 27, 2013 10:24|
|Boundary Layer||mahadevan.swamy||FLUENT||1||June 29, 2009 08:10|
|GAMBIT problem with 3D Boundary Layer when meshing||Anthony Haroutunian||FLUENT||2||March 26, 2008 03:02|
|Convective Heat Transfer - Heat Exchanger||Mark||CFX||6||November 15, 2004 15:55|
|Please help with flow around car modelling!||Tudor Miron||CFX||17||March 19, 2004 19:23|