|
[Sponsors] |
January 9, 2011, 12:52 |
Gambit
|
#1 |
Member
Guiliguili
Join Date: Aug 2010
Location: Montréal
Posts: 97
Rep Power: 15 |
I want to select one line but all the lines of of the drawing are selected when I click on the drawing. I don't know why ?
|
|
January 10, 2011, 01:56 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
did you import your geometry?
a picture may hel to understand your issue
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
January 10, 2011, 12:13 |
|
#3 |
Member
Guiliguili
Join Date: Aug 2010
Location: Montréal
Posts: 97
Rep Power: 15 |
I did not import any geometry. It happens when I want to mesh the edges one by one. It picks all the edges at the same time instead of one.
|
|
January 11, 2011, 00:46 |
|
#4 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
If you go to Geometry/Summarize edges, are you able to pick just one edge, or gambit selects again all the edges?
In other words, did you merge all the edges?
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit Startup Window | Jay Shim | FLUENT | 2 | February 12, 2015 14:05 |
Gambit help: Cube inside cube | Jack Martinez | FLUENT | 13 | August 11, 2010 06:29 |
Gambit 2.3.16, Xming or Exceed...HELP! | bambam3417 | FLUENT | 10 | May 7, 2010 12:39 |
Does Gambit has a maximum allowable grid number? | spartan1516 | ANSYS Meshing & Geometry | 7 | March 25, 2010 09:08 |
Gambit -dev X11 doesn't work | Ervin Amet | FLUENT | 0 | October 28, 2007 08:33 |