|
[Sponsors] |
January 8, 2013, 03:10 |
Hybrid mesh with non uniform y_plus
|
#1 |
Member
Johannes Ringborn
Join Date: Nov 2012
Posts: 40
Rep Power: 13 |
Dear all,
I try to create a hybrid volume mesh. After having done an initial calculation (with a distance of 10e-06m of the first gridilne) I get a non-uniform y_plus evolution along the wall (see attached image). Is there a possibility in ICEM to create a hybrid mesh with a linear decrease of the distance of the first gridline from the wall (in this case from 5*10e-05m to 10e-08m) and a constant exponential increasement-factor? I am thankful for any help! Best regards |
|
January 15, 2013, 08:52 |
|
#2 |
Member
Johannes Ringborn
Join Date: Nov 2012
Posts: 40
Rep Power: 13 |
I am sorry to bring up this post thread again, but any suggestion would be really helpful.
Regards |
|
January 15, 2013, 09:11 |
|
#3 | |
Super Moderator
|
Quote:
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit problems | Althea | FLUENT | 22 | January 4, 2017 03:19 |
FLUENT - ICEM / Segmentation Violation Error (Hybrid Mesh) | Joachim | ANSYS | 3 | April 24, 2016 16:52 |
[ICEM] Negative volume error in hybrid mesh | siw | ANSYS Meshing & Geometry | 4 | September 3, 2014 05:25 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Pressure instability with rhoSimpleFoam | daniel_mills | OpenFOAM Running, Solving & CFD | 44 | February 17, 2011 17:08 |