|October 30, 2011, 08:21||
merge/virtual topology problem
Join Date: May 2011
Posts: 11Rep Power: 7
I have a problem with my geometry which I have formed using CATIA v5.
Please imagine my geometry that, there is a body and there are another two
bodies on the first body. So one face of the first body is in contact with
totaly two faces of other two bodies. And I formed one part and three bodies
with these parts.
When I import geometry into design modeller, the face of the first body (in
contact with two faces of other two body), is single (that is no need to
merge).But when ı continue with ansys/meshing, I see that this face (in
contact with two faces of other two body), is divided into two. So I tried to
use virtual face but it gave an error. But as I said first I can not see these
two faces at design modeller (they is on face). So I can not use sweep
What is the problem. Thanks in advanced.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem with interFoam; Wave/wiggle alpha1 behavior||JonW||OpenFOAM||3||February 23, 2013 21:41|
|UDF compiling problem||Wouter||Fluent UDF and Scheme Programming||6||June 6, 2012 04:43|
|Problem in implementing cht||tilek||CFX||3||May 8, 2011 08:39|
|natural convection problem for a CHT problem||Se-Hee||CFX||2||June 10, 2007 06:29|
|Adiabatic and Rotating wall (Convection problem)||ParodDav||CFX||5||April 29, 2007 19:13|