|
[Sponsors] |
November 8, 2011, 09:58 |
Problem with a narrow gap
|
#1 |
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 17 |
I was simulating the flow over some solar panel surfaces to compute the wind pressure on the panel surfaces. There is a narrow gap in between the panels and it is desired to have a good volumetric mesh refinement in this gap. I’ve used the curvature/proximity based refinement but that didn’t really help.
Could someone please suggest me the apt way to do this in ICEM. Please find attached to this post a pdf that can provide a better illustration to the problem.
__________________
Best regards, Santhosh. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with interFoam; Wave/wiggle alpha1 behavior | JonW | OpenFOAM | 10 | February 4, 2023 07:27 |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Problem in implementing cht | tilek | CFX | 3 | May 8, 2011 08:39 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |