|
[Sponsors] |
[ICEM] icem the same block parallel line dont have the same node |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 8, 2023, 21:42 |
icem the same block parallel line dont have the same node
|
#1 |
New Member
Join Date: Jun 2023
Posts: 1
Rep Power: 0 |
I can't decide why, try to change one line's node into x, but the opposite line always keeps x+1, I don't know why, the line and node are also associate already, I don't know if it is because I delete some block ,or any questions about the node or the geometry,
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM benchmarks on various hardware | eric | Hardware | 778 | April 23, 2024 16:56 |
[OpenFOAM] ParaView command in Foam-extend-4.1 | mitu_94 | ParaView | 0 | March 4, 2021 13:46 |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 08:48 |
Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |