|
[Sponsors] |
December 5, 2011, 21:07 |
Cylinder with slots meshing
|
#1 |
New Member
Kaushik
Join Date: Dec 2011
Posts: 16
Rep Power: 14 |
Hi...I am very new to the gambit software and wish to know how to specify the boundry zones for a cylinder with slots. I am trying the 2d meshing for the same. Kindly help me in understanding the concept because when I am getting an error saying the boundry condition specified is invalid for all the edges.
Thanks Kaushik |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
meshing on cylinder fails ICEM | potac | ANSYS Meshing & Geometry | 0 | October 25, 2011 05:21 |
2D planar cylinder meshing problem | saisanthoshm88 | ANSYS Meshing & Geometry | 15 | December 27, 2010 11:14 |
[ICEM] (ICEM CFD) meshing over a cylinder | vmlxb6 | ANSYS Meshing & Geometry | 6 | August 11, 2010 14:37 |
[blockMesh] Meshing inside a cylinder so that the edges contain more cells than the center | Bertrand | OpenFOAM Meshing & Mesh Conversion | 1 | April 13, 2010 04:46 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |