|February 19, 2012, 18:09||
How to draw ellipsoids in Ansys workbench
Join Date: Mar 2009
Posts: 105Rep Power: 8
I'm trying to draw an ellipsoid as shown. When the plan view is a circle (ax=az), I can draw a section of it and revolve 360deg.
However, if ax/=az, how do I do it?
|Thread||Thread Starter||Forum||Replies||Last Post|
|ANSYS Workbench on "Uncertified" Linux Distros||hsr||CFX||239||September 26, 2015 08:21|
|[ICEM] what does the different ANSYS ICEM and ANSYS Workbench?||agungwp||ANSYS Meshing & Geometry||7||October 27, 2014 21:12|
|Macro command combatibility ANSYS workbench||Tassos||CFX||6||January 13, 2014 05:19|
|Ansys workbench problem||Jonny6001||ANSYS||2||September 30, 2010 12:59|
|Export Heat Flux CFX -> ANSYS Workbench||Freeman||CFX||2||April 11, 2010 08:24|