|October 28, 2012, 21:40||
Default defeaturing tolerance error
Join Date: Sep 2012
Posts: 12Rep Power: 4
I am trying to model an airfoil in 2D in fluent. When I generate the mesh I get the following error:
"The default defeaturing tolerance was larger than one computed based on size controls. The mesher has modified the global defeaturing tolerance accordingly."
When this happens one of the mesh quadrants goes weird as shown in the picture.
Anyone know how to get round this? There are a couple of threads already on this topic but no solution has been suggested.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Compile problem||ivanyao||OpenFOAM Running, Solving & CFD||1||October 12, 2012 09:31|
|Ansys Fluent 13.0 UDF compilation problem in Window XP (32 bit)||Yogini||Fluent UDF and Scheme Programming||7||October 3, 2012 07:24|
|error while running paraFoam!||padmanathan||OpenFOAM||9||October 13, 2009 05:17|
|Installation OF1.5-dev||ttdtud||OpenFOAM Installation||46||May 5, 2009 02:32|
|Problem with compile the setParabolicInlet||ivanyao||OpenFOAM Running, Solving & CFD||6||September 5, 2008 20:50|