|
[Sponsors] |
March 15, 2004, 08:46 |
pro*am issue
|
#1 |
Guest
Posts: n/a
|
Hi all, I am doing tetra mesh in pro*am. But while creating sub-surface proam is creating uneven offsetting. Somewhere it is giving more spacing somewhere less. Because of this there are intersection of cells. Did anybody face this problem? I tried lot of option in proam to create good sub-surface. Is this a function of good shell (tri) mesh? Kindly guide.
|
|
March 18, 2004, 15:51 |
Re: pro*am issue
|
#2 |
Guest
Posts: n/a
|
The quality of the surface mesh is very important for the creation of the subsurface. There are several ways in proam to deal with this problem. You can try the "resurface" at first.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
y+ and y* issue | Freeman | FLUENT | 9 | December 6, 2017 11:46 |
Geometry Issue! | Mann | CFX | 2 | January 14, 2008 16:33 |
CHT issue | john | Siemens | 0 | May 10, 2004 03:26 |
pro*am issue | carno | Siemens | 3 | October 23, 2003 04:32 |
CHT issue | carno | Siemens | 3 | September 23, 2003 01:30 |