|
[Sponsors] |
December 30, 2004, 16:05 |
Recirculation problems
|
#1 |
Guest
Posts: n/a
|
I am simulating a simple diffusion flame. I am using a 2D square mesh. One side of the square is the two inlets (fuel stream in the center, the rest is the oxidizer stream) and the opoosite side is the outlet. The velocities of the streams are O(cm/s). The problem is that I don't get a converged solution, because I keep getting inflows at the outlet boundary, along with recilculation regions. Could the boundary conditions be faulty? Any suggestions are more than welcome.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to do recirculation problems in fluent | arvind | FLUENT | 0 | October 14, 2008 00:58 |
Recirculation | Abdul | CFX | 3 | June 25, 2007 03:35 |
Recirculation | Simran Saini | FLUENT | 3 | February 1, 2007 02:02 |
Recirculation | Simran Saini | FLUENT | 1 | January 18, 2007 22:51 |
recirculation | ander | Main CFD Forum | 1 | October 30, 2000 05:15 |