VIEW FACTOR CALCULATIONS

Cedric

Hi all,

I am facing problems with radiation patches: I am working with a model with radiatioan activated, defined patches on the boundery conditions... and it works fine (geom file is OK, and calculation of *.vfs file just befor the solvinng phase works (View Factor Calculations)) Now I want to refine the dimenssion of my patches, lets say from 100 to 50 or even 20 (I did try both). Then if I launch the updated model, the solver does not actually run as the file *.vfs is not written! The calculation of the view factor gets stuck half way through... I frequently ask the support but on that issue got no explaination so far.

Hopefully some of you guys already encounter the same problem and could give me a hint...

Thanks in advance,

Cedric