|
[Sponsors] |
October 10, 2007, 16:42 |
EMERGENCY HELP ME NEGATIVE DENSITY IN ES-ICE
|
#1 |
Guest
Posts: n/a
|
i made my model in es-ice,i used trimmed cell and there wasnt any negative volume cell then i imported my model into prostar, i gave required values in prostar and finally i wrote star -dp and i launched analysis ,iterations were going but after 80 iteration prostar stopped and it said there were more than 100 negative volume cells what will i do? what should i do? help meeeeeee
|
|
October 10, 2007, 18:13 |
Re: EMERGENCY HELP ME NEGATIVE DENSITY IN ES-ICE
|
#2 |
Guest
Posts: n/a
|
have you attended the spray and combustion and moving mesh training course? Most of the answers are there.
cd-adapco also have a knowledge base in the site where you download the software, most of the answers are there as well. You can search the knowledge base to have the answers. You need to ask your account manager to enable you access. good luck bee |
|
October 10, 2007, 19:31 |
Re: EMERGENCY HELP ME NEGATIVE DENSITY IN ES-ICE
|
#3 |
Guest
Posts: n/a
|
Sounds like you have a problem with the grid motion.
Remote diagnosis is rather difficult. |
|
October 12, 2007, 15:21 |
Re: EMERGENCY HELP ME NEGATIVE DENSITY IN ES-ICE
|
#4 |
Guest
Posts: n/a
|
i think i have internal face around the port there are couples face i tried to delete inter face by cp match but it wouldnt be succesful also i tried to delete in proam but it wouldsnt be succesful either
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Negative density | Gopi | Siemens | 0 | April 3, 2007 06:49 |
negative density | novice | Siemens | 1 | March 15, 2005 09:27 |
Negative Density | Wendy Tjia | Siemens | 6 | November 26, 2004 10:45 |
negative density | Jane | Siemens | 4 | March 9, 2004 21:01 |
Negative Density | Sangwon Kim | Siemens | 20 | May 8, 2001 08:49 |