|
[Sponsors] |
August 13, 2015, 23:59 |
Request for assistance with 2D mesh?
|
#1 |
Senior Member
CFD
Join Date: Nov 2010
Location: United States
Posts: 243
Rep Power: 16 |
Hello All,
I would like to find someone helpful with 2D meshing (gmsh+simpleFoam). The aim is to perform grid convergence study and validation. I have no problem to pay for help. But it is very important and urgent ! The simulation must be done on Gmsh and simpleFoam simulations. Thank you in advance. Last edited by tareqkh; August 15, 2015 at 17:57. |
|
August 18, 2015, 05:33 |
|
#2 |
New Member
Al_th
Join Date: Apr 2015
Posts: 19
Rep Power: 11 |
Hello tareqkh.
Could you provide more information in PM about your problem so I can assess my expertise and see if it fits your requirements ? Best, Al_th |
|
September 8, 2015, 08:22 |
Grid convergence study using richardson extrapolation
|
#3 |
New Member
Sourabh Jain
Join Date: May 2014
Posts: 15
Rep Power: 11 |
Hi,
I have performed grid convergence study using richardson extrapolation with 3 solutions as input. Can you provide the geometry and boundary condition details. You can contact me on sourabhjbp@gmail.com Sourabh |
|
October 18, 2015, 12:16 |
help required
|
#4 |
New Member
HSA
Join Date: Oct 2015
Posts: 2
Rep Power: 0 |
i also need help ... i am just a beginner with fluent... i have to model a rod with 5mm radius and extended in z direction upto 1 m .. i want to write a udf for heat generation rate as a sine function varying along z direction (maximum at the centre and zero at the edges...) can any one help me with... i'll be thankful
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
[ICEM] Mirror Mesh | Delete duplicate mesh | pythag0ra5 | ANSYS Meshing & Geometry | 6 | November 19, 2013 07:35 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
[OpenFOAM] Saving ParaFoam views and case | sail | ParaView | 9 | November 25, 2011 15:46 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |