Ansys mixing vessel(freelancer needed) -- CFD Online Discussion Forums

October 22, 2015, 14:49

Ansys mixing vessel(freelancer needed)

Edreez

New Member

Idris

Join Date: Jun 2015

Posts: 8

Rep Power: 10

Help needed please, any inputs would be invaluable in this, i'm trying to do simulations of a mixing vessel as attached and i'm not so sure which solver i should use, the pressure-based solver or the density based solver. because the vessel is to be heated at a constant temperature of 333K and the fluid is at a temperature of 301K, the fluid to be mixed is a non-Newtonian fluid, Solidworks was the CAD software used and was imported into the ANSYS WORKBENCH.

Attached Images

KIA impeller assembly.JPG (56.4 KB, 64 views)

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Command Line Run for ANSYS	Liaquat	ANSYS	11	April 19, 2018 09:49
[ANSYS Meshing] remeshing in Ansys CFX - help or tutorials needed	Doginal	ANSYS Meshing & Geometry	6	September 24, 2014 09:43
compiling firefoam	Farshad_Noravesh	OpenFOAM	27	December 24, 2012 04:21
Is Gambit needed for Ansys Fluent 12	kbaker	FLUENT	3	February 16, 2011 17:57
Help needed in ansys meshing	kjayatunga	ANSYS	2	May 4, 2010 11:20

All times are GMT -4. The time now is 08:15.