|
[Sponsors] |
May 14, 2012, 00:46 |
Name Selection of a surface
|
#1 |
Member
Alireza Safikhani
Join Date: Dec 2010
Posts: 36
Rep Power: 15 |
Dear friends,
My geometry is a simple spherical with a hollow in that, is there any way to select the inner surfaces with name selection tools? in fact the inner surfaces are not visible and for selecting them in the name selection is hard. Sincerely |
|
May 14, 2012, 01:59 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
Use the selection tools in the bottom left corner of the screen to select bodies other than the one in front. Have a look at the Workbench tutorials for examples of how to use them.
|
|
May 15, 2012, 09:35 |
|
#3 |
Senior Member
Join Date: Jul 2010
Posts: 152
Rep Power: 15 |
you can simply make a named selection and then toggle off visibility of this named selection. Then selection of inner faces will be easy.
regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
continuum surface tension model | yukn | Main CFD Forum | 0 | October 8, 2011 06:43 |
Selection Surface for contour plot by journal file | diamondx | FLUENT | 0 | September 12, 2011 11:58 |
Surface Tension Test Cases | sega | OpenFOAM Running, Solving & CFD | 2 | March 8, 2011 12:19 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |