|
[Sponsors] |
October 24, 2012, 13:37 |
Compressor simulation issue
|
#1 |
Member
Vit Houst
Join Date: Apr 2012
Posts: 35
Rep Power: 14 |
Hello,
I have a following problem. When running compressor simulation, I cannot get some points to converge. In general this problems occurs in the middle of the measured maps, but at this point the measured speedlines are already falling down or horizontal. it generaly falls on overflow problem. Is there a way how to change the criterions to prevent the simulation from falling? When i watch the measured parameters etc. evertyhing seems reasonable. Thanks Vit |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
convergence issue with multiphaseInterFoam | sachinlb | OpenFOAM Running, Solving & CFD | 2 | October 12, 2012 11:45 |
Pressure boundary condition issue | Vijay | FLUENT | 0 | April 6, 2012 13:35 |
Meshing related issue in Flow EFD | appu | FloEFD, FloWorks & FloTHERM | 1 | May 22, 2011 08:27 |
Issue Involving Paraview | MechE | OpenFOAM | 22 | October 31, 2010 08:29 |
Memory issue - Suse 10 - Opterons | Andy R | FLUENT | 1 | June 23, 2008 14:44 |