[Hitch8]

Hi everybody,

I have some problems implementing a heat flux boundary profile at a fluid-porous interface. In realitiy this heat-flux is caused by thermal radiation which heats up the porous material. In my simulaiton the heat flux caused by the absorbed thermal radiation is just modeled by applying a heat flux boundary profile at the porous-fluid interface. I want that the heat flux is applied to the solid part of the porous domain. Therefore, I've implemented a boundary source at the interface of the fulid-porous domains.
Source -> Boundary Source -> Solid 1 -> Equation Sources -> Energy-> Flux => Boundary Profile....Wall Heat Flux (x,y,z).
What confuses me is the solid values tab; in there the boundary conditions for the solid also needs to be defined.
Does anybody now if I should define my boundary heat flux profile only in the source tab or only in the solid values tab or in both?

Thank you very much in advance!